Home > Free Patterns > Positive Karma Bracelet

All available patterns

Positive Karma Bracelet

Pin It

Materials Needed: 12ft Leather Cord- Dark Brown- Sold Out - ($2.75) 40' 24 Gauge Wire- Silver - ($2.69) 20mm Swarovski Cosmic Ring Pendant- Silver Back - ($9.50) #34719059- 145pc Starter Pack- Silver - ($4.00)
Tools Needed: Needle Nose Pliers w/ Cutter - ($4.00) Side Cutter Pliers - ($4.00)

Instructions:

Cut (2) 6 1/4 " lengths of brown leather cord.
Cut (2) 3" lengths of silver wire.
Thread a cord through the cosmic ring and fold it in half. Bring the cord sides together.
Approximately 1/4" from the cosmic ring place the wire flush with a cord on the inside where the two cords touch. Tightly wrap the wire 6 or 7 times around the two cords. Bring the wire back through the center where the two cords meet. Trim the wire just before the edge of the cord. This will prevent the wire from being exposed to rub against the skin.
Keeping the cords flush against each other be sure to check that the ends line up. If not, trim the excess cord.
Use a cord end to secure the leather cord. Use a 4mm jump ring to attach a toggle end to the cord end.
Repeat steps 3-6 for the other side of the bracelet.